Software

DepenLoop

DepenLoop is software for reliability and safety studies. It brings risk assessment, SIL and PL safety functions, fault trees and the study report together in a single project file.

Project view in DepenLoop: study summary and scenario tracking
Demonstration project open in DepenLoop. The interface is in French.

Principle

The software takes its name from the loop a study follows: the calculated result of a safety function is carried back into the risk assessment, where it justifies the final risk rating.

1234Risk reductioniterative process
  1. Risk assessmentDesign-stage assessments, risks to people, risks to property, FMECA. Each line is rated.
  2. RequirementA line whose risk is not acceptable gives rise to a safety function, with its required SIL or required PL.
  3. Architecture and calculationThe user describes the architecture: components, voting, common cause failures. The software calculates the level achieved.
  4. Back to the assessmentThe final rating relies on this calculation. If the function is changed, the line concerned is flagged.

Modules

Risk assessment and FMECA

Four types of analysis are kept in the same table: initial and final ratings, risk reduction measures, and a link to the safety function or fault tree that provides the risk reduction.

Risk assessment table in DepenLoop: lines, ratings and measures

SIL and PL safety functions

Each function is described by a diagram: input, logic, output. The software calculates PFDavg, PFH, category, MTTFD, diagnostic coverage and common cause failures.

SIL calculations follow IEC 61508, IEC 61511 and IEC 62061. PL calculations follow ISO 13849-1. Each result is shown with its equations.

Safety function in DepenLoop: three stages and calculated performance level

Fault tree analysis

Gates, basic events, minimal cut sets, probability at a given time. A safety function that has already been calculated can be used as an event in a tree.

Fault tree in DepenLoop

System description beta

Functions, equipment, connections, zones and hazardous events are described once. This description is then used to prepare the assessments, the safety functions and the fault trees.

Architecture diagram of a machine in the SYSTÈME module of DepenLoop

3D models beta

Each type of machine has a schematic 3D model. It can be rotated with the mouse or a finger; hovering over a part shows its name. The module shown here is the one used in the software.

Loading the model. It requires a recent browser (WebGL 2).

The models are used to identify the machine. No calculation value is taken from them.

Study report

The report includes the project summary, a sheet for each function, the diagrams, the minimal cut sets and the data used. It is assembled chapter by chapter and exported as a PDF.

Reports are currently produced in French.

Page of a study report produced by DepenLoop

Software status

Available

  • Risk assessment and FMECA
  • SIL and PL safety functions, common cause failures
  • Fault trees and minimal cut sets
  • Availability: MTBF, MTTR, downtime
  • Standards compliance matrix
  • Verification benches for the calculation engines
  • Study reports

In beta

  • SYSTÈME: system description and 3D models
  • MARKOV: state models
  • SIM: Petri nets and simulation
  • PredictM: predictive maintenance

In development

  • Assistant: reads a functional analysis and prepares the project file, under the engineer’s control.

Practical information

Versions and language

DepenLoop is updated regularly; the version online is shown at the bottom of this page and in the software. The interface and the reports are currently in French.

Checking results

Each calculation shows its equations, its assumptions and the standard applied. The software does not issue certification and does not replace review by an engineer.

Data

Work in progress is stored in the browser. A project file is uploaded only if the user chooses to do so.

Access to DepenLoop

Access is requested online. Sigmastra activates it after reviewing the request. No payment is taken on the site.

Team licences: terms are agreed case by case. contact@sigmastra.com